Recent content by markjonesx

Yes, it running at FF, I have just updated the bios, will do more testing, report back later.

Tagan 1100W, the beeping has no set interval? beeps just once, definately a bios beep? Computer works fine apart from the beep??????? or seems to?

I have just built my new rig; Intel QX6700 Quad - Water Cooled EVGA 680i EVGA 8800GTX (2 off SLi rig) Memory, Corsair CM2X1024-8500C5D Boot up everything fine, simple applications everything OK. Just started to test on COD2, everything set on the highest graphics levels etc, every 2...

I've just set up my CPU & Heat Sink using Artic Silver 5. Do you have to wait for the Arctic Silver to dry for 24 hrs? Can I just start my PC up?

I'm currently installing a WC system in my new computer, I have fired up the WC system, pump runs OK, however, it is full of micro bubbles which I'm trying to bleed out. I think I have a problem, my resevoir; http://www.thecoolingshop.com/product_info.php/cPath/33_61/products_id/1773 My...

I'm still building the computer, CPU isn't in yet, or the water cooling or the HDD.......

OK, so I plug my monitor in either position 1 or 2? right?

I may be being a bit stupid, but.... which of these ports connect to my monitor 1, 2, 3 or 4 or a combination? http://img155.imageshack.us/img155/6085/dsc00679zn3.jpg I have 2 x 880GTX for SLi configuration.

D-Tek Fuzion CPU + Laing DDC-1T

Which of these setups is the best/correct? anyone got any other diagrams; http://img216.imageshack.us/img216/7082/scan0001zj3.jpg Thnx in advance.

I'm in build att the moment, I have 2 x EVGA 8800GTX cards, however, I'm a little bit confused, the SLi connector has 2 positions? which one does it go in? see photo; http://img206.imageshack.us/my.php?image=dsc02742pr8.jpg One last question, I assume I hook up all 4 power ports...

I used to design cooling systems in the Auto industry, pullers are always better on performance (you'll notice car radiators always sit behind the Rad). You also have to optimise the distance from the core, by testing. Just wondered if there was any difference in computing?

I'm building a new rig, it will have water cooling Thermochill PA120.3 rad. Which way is the best for air flow; 1. Air inside the case blown over rad and out 2. Air inside the case sucked over rad and out 3. Air outside the case blown over rad and into case and out 4. Air outside...

I'm in the process of building a new rig, but I am a bit confused. The fans which have LED in to light them up; 1. Do they just have a 3 pin connector? 2. Do they have a 3 pin to control the fan and a 4 pin to light the LEDs? Anyone got any diagrams? I'm going to use Akasa FC-03...

We get ripped off in the UK, $200 = £200