It makes plenty of sense sooner it is out the sooner drivers will be created. I am up and running on it and the only driver I am missing is my printer: Samsun ML-1740.
SP2 fixed it though it was not listed in MS documents as a fix. I had been waiting to load SP2 on this box as when I did the first time it had some major issues.
The average read speed did not increase much and is arounf 60-66MBs, but the burst is up around 100-110MBs. So not too bad...
Its a bit more than 5%, but thats not the point at all. The point is both devices I have support it and at the hardware level the drive is seen as DMA 6. The problem is that windows does not. So rather than debate the speed issue does anyone have any ideas? As already stated the systems was...
I have just purchased a new Maxter hard drive and it is ATA133. For some reason it will only run in DMA 5 or ATA 100. I am using a ASUS A7V8X-X motherboard that does support it. Any ideas as it does show in the bios as DMA 6.
I have also tried the following:
1. Removed reg settings to...
Yes that is very true, but the one I have still has some life in it, and I don't feel like building a who new PC right now. So the CPU/VID Card upgrade should be enough for a few months.
Kyle
Well that is why I might just do the video card now, but i'm wondering how much lacking 8x AGP will matter?
I could then do the mobo, cpu when the bus speed goes beyond 333mhz.
Kyle
Thats interesting... Now i'm more confused.
2400XP is only $100, but I don't think it will be that much faster than my 1600xp.
9600pro is about $180.
So I can get both for about $280, but from the looks of your post it might be better to just get the vid card.
Hmm...
Kyle
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.