Recent content by jeremySanDiego

well, it cannot be blown, or I wouldn't have buzzed it out.. so.. try a new PSU? will seasonic repair/replace the current one?

fuse IN the power cable? I didn't realize they have fuses. I didn't see any and all the lines buzz out <1 Ohm.. jeremy

Okay, gettiing 0V on every pin. Shorting GRN to ground does nothing. I have every power sink disconnected (except fans). So, Do PSUs generally have warranties to cover all uses? I really don't think the power supply would die like that. Isn't this uncommon? thanks, jeremy

The asus manual says clearing CMOS isnt necessary after a shutdown due to overclocking. It says there is a CPU parameter reset feature that just requires a reboot. I did it anyway, along with reseating the CPU and I still have nothing.

reseat or reset?? How do you reset the CMOS?

I normally overclock 103% (been running for months). I left my computer on @108 and it went off overnight. Now the power supply doesn't go on. Doesn't it need a signal from the MB to turn on? I tried disconnecting various power sources, but that is no help,eh? Is there a way to tell if I fried...

So, everyone else can get 5.1 digital out ok?? using the ASUS util, you can hear all 6 channels?

flibidyflob, "Did you use the speaker setup utility (test sounds) in the Realtek soft so that you know you have the speakers plugged correctly?" plugged in? I am using spdif to my receiver. "Is what you're listening to actually 5.1?" I am using the ASUS speaker utility. You can...

Sorry, should have mentioned: 1. realtek is installed. 2. sound mgr untility set to 6CH, didn"t help 3. control panel shows 5.1 sound on the realtek, driver reports working properly Kman, I am no where near an expert, but i cn try and answer your SPD question. Short answer: SPD =...

I can't get 5.1 sound out the MB. Only 2.0.. but reciever works fine on 5.1 source. Any ideas?

just restarted from scratch and now windows saw one 140mb disk.. we'll see how this goes

I probably won't be doing any recording for awhile, I can buy a bigger HD later. At this point, I own two 74 raptors and would like to get raid 0 working. Yes, the MTBF is halved, I am ok with that. If I even get a little performance inprovement, I am happy. Now, I am assuming I should see...

so why is mce raid 0 pointless? anyway, got an OS up by installing both drivers. But two issues: it couldnt fine iexplorer.exe on any disk given, and I dont appea to have the full raid. C: driver shows 80mb, but device mgr shows 160mb stripe??

I am using an ASUS A8N SLI-Premium MB. My install fails to boot. Here are some observations: 1. my BIOS doesn't show the HDs (WD raptor 78 (2) ) when I use the Nvidia BIOS to config RAID 0. But when it is booting, it shows the 150+MB RAID when it gets to the nvidia BIOS section. normal, I...