Recent content by jattboy

  1. J

    Testing port level connectivity

    Thanks Spidey07 and Sosobear, I will try your suggestions.
  2. J

    Testing port level connectivity

    Hello All, Let's say you are having problem with VNC connectivity. You can ping the remote computer but TightVNC is not working. In TightVNC you are tying to connect to IP address::23 (ie: 192.168.2.1::23). The error you get is "failed to connect to port". Is there any utility or...
  3. J

    Ping not working in Frame relay

    Thanks ScottMac, you were right. I put "frame-relay map ip" to router's own interface and the ping works. Also the time is double to ping your own interface than to ping the other router on other side of the Frame-relay switch. Here is what I did: int s0 frame-relay map ip s0(IP address)...
  4. J

    Ping not working in Frame relay

    Hello All, Here is the topology diagram for my lab: (R1) -------- (FR/R2) ------- (R3) R2 is configured as Frame Relay Switch and all the configuration is done correctly. R1's Serial 0 is connected to R2's Serial 0 and R1 DLCi is 103 R3's Serial 1 is connected to R2's Serial 1 and R3...
  5. J

    Bus Master IDE Controller...

    Hi Kalisperas, Were you able to resolve you issue? I am having the same issue and my motherboard is Soyo (SY-7VBA 133), where I have tried the 4 in 1 driver. I did not have this problem before when I had winxp and win98 running on this computer but I had to reinstalled OS and now I only...
  6. J

    Multiple IP addresses with T1

    My suggestion would be that you use private IP addresses inside your network and use Network Address Tranlation (NAT) feature on Cisco router to forward the public (outside, in your case 100.100.100.11) IP address to inside local addresses.
  7. J

    Options for access server

    For this product eBay does not ship to Canada. This is for my lab simulation, where all three routers are connected using serial cables. I have not been able to find any good solution. Here is what I am going to do: - Use three console cables. - Use two com ports on one PC and run...
  8. J

    Options for access server

    Hello All, I am studying for Cisco certification. I have three Cisco 2500 series routers and none of them have "Async" port. Right now, to access each router I have to keep swaping the console cable. I would like to make an access server so that I just connect the console cable there and...