Recent content by GhandiInstinct

I have 4 120MM fans in my Cooler Master case. 2 Are hooked up to Chassis1 and Chassis2 on the mobo 1 is hooked up to Power Fan 1 is through PSU Chassis 1 doesnt go higher than 475 RPM even if Asus Xpert fan is on Turbo And the Chassis 2 and Power fans are at 700RPM and 800RPM...

Good to know. I'm trying to figure out what's the controller part when I open up the cell phone. Do you know the website for Soft-center and Ace Labs? I couldn't find one just googling. And do you by chance know the name of the software to read the raw data and how to scan it?

Amazing information. Could not find this googling haha. So here's the thing, I have one source that says he can do what you're talking about. Re-balling the flash chip onto a reader and reverse engineering the file system. He's 19, he jailbroke the iphone was in the news etc...but he's...

I have a Moto Z9. The messages by default are saved to the phones NAND. The drafts were cleared during a SIM switch and the data was important. Most companies can't do such recovery cause its a new frontier. Here's what I have so far as to the possibilities - Re-Balling the NAND chip...

Real quick - I have a Moto Z9. The messages by default are saved to the phones NAND. The drafts were cleared during a SIM switch and the data was important. Most companies can't do such recovery cause its a new frontier. Here's what I have so far as to the possibilities -...

Anyone have experience with accessing the embedded flash chips in cell phones for recovery or otherwise? I have a hex reader I need to use for lost data that was saved to my phones message folder.

Anyone have experience with accessing the embedded flash chips in cell phones for recovery or otherwise? I have a hex reader I need to use for lost data that was saved to my phones message folder.

Good point. I'll manually set the defaults then myself rather than leaving them on auto.

Turbo is turned off. As in my Signature: 3GB Dominator 1600 8-8-8-20 Zalman 9900 I tried a variety of manual ram and QPI settings which also did not POST properly so I'm not sure.

Hey guys, I had trouble OC'ing manually inputting the numbers. I kept getting a shut off on "Exit Saving Changes" and then it reset by itself with the monitor not turning on. I then manually re-powered and it POST'ed to "Overclockfail". I was inputting standard settings that others...

I'm looking for software that can recover data off an unresponsive hard drive that states inaccessible and corrupted. Everything I found costs a lot of money I'm looking for a free program.

Whats your OC at?

For each core I'm getting 28-32C at 0% cpu usage, I ran Prime95 for a few minutes on Small and Large FFT and it goes to 50C Are these normal? It seems with the Aftermarket heat sink I should have cooler temps?

All 3 SATA hard drives are connected to the SATA hub on my P6T Deluxe Asus. In BIOS it shows all three, but in my computer and disk manager the third is not showing. What's up? It only gives me an option to conver it to a basic disk, I cant I have data on it. How do I enable it? I...

I'm thinkin 200 BCLK is too high on 1.2V ? I have DDR3-1600, to have 1:1 I need to have what multiplier on the ram for 3.2GHZ cpu speed? 166 BCLK and adjust the memory to 8x 166? And viola?