Recent content by gargula

Lexmark's support got back to me with the solution: 1. Power off the printer. 2. Open the printer cover. 3. Press and hold the Cancel and Continue buttons (the top two buttons). 4. While holding down these two buttons, power the printer back on. 5...

Using the reset to factory defaults resets everything *except* the network settings, which is exactly what I need to reset... :( I wonder if it's possible to use that page via the USB cable?

I have deselected the option "Enable DHCP Client" of my Lexmark E120n network printer via its web configuration page. Now, the printer doesn't acquire an IP address from the router (it reports its IP as 0.0.0.0) and I don't know how to reach its web configuration page (because it doesn't have an...

Using the analog VGA connector works fine. If I use the DVI one then it doesn't show anything for some minutes after boot. After some time, the image comes up. If I change the resolution in Windows or if I run a game which changes it, the image goes away again for a long time (I'm talking...

My ANTEC Overture case came with an addendum to its manual which showed the correct wiring of the 1394 connector - the description in the manual itself was wrong. After swaping only two wires (7 and 9) plus removing the plastic piece from position 10 I was able to connect it to the motherboard...

This page http://www.frontx.com/head_con.html *may* be helpful if you want to re-assign the pins in your case's connector to match your motherboard's pin order.

The following article talks about a similar issue with USB connectors -- but it helps with Firewire as well: http://shop.store.yahoo.com/directron/installusb.html It has to do with bloody Gigabyte not following the de facto standard (Intel) for pins assignment. I knew that I should have...