Recent content by FullMoon

My recommendation on my own experience is the Soyo 6BA+100 (133). I own one of those and purchased another one for other system. It is so good and stable, overclocks easily and is a BX chipset. It has a High Point 370 Controller 33/66/100 for Hard Drives, also Raid. Im using a Pentium III 600E...

I love my SOYO

Thanks, I already have a replacement coming in, from another vendor. More expensive but next time I try that place. Prices are better.

I need a Winbond W29CO20-12 Flash Rom Chip. I've been searching for a place that sells those chips. If anyone knows a place let me know. I need to have copies of the Bios for my systems.:cool:

Thank you all for your responses. Next time I will be more prepared. I al ready ordered an RMA request. It was a brand new Board. This time I will start formatting HDD.:(

My Abit Board BF6 system started beeping one night continuously. When I checked it out the next day it was doing the same thing. After checking everything over and over again and flashing the Bios, I came to the conslusion that the Board was Dead, so I ordered a new Board this time a Soyo...

I had something similar. My system with an Abit BF6 started beeping continuously and lost all bios. Tried flashing it and the same thing. I boutht a new Mainboard and after installing it and while windows was detecting hardware (video card,audio etc.) it started crashing and everytime I started...

You should take a look at the new Abit SA6R. It should be a good one to consider due to the features. If I would go to get a new one, I would buy that one. I upgraded recently to a Soyo 6BA+ 100 and the Highpoint 370 controller is Superb. That is the reason I suggest that Abit Board because it...

Is there any place that I can buy IRQs and DMA channels?:|

Try to assign an independent IRQ to your audio card if there is any available. You have to do it manually. Some settings allow sharing and you have to set it in audio properties.

I made an CUSL-2 system and had to many problems with IRQ and DMA conflicts. I almost gave up. Finally I had to do it manual and assign each one. On auto there were conflicts. Also when I set the PNP (OS) on yes, had conflicts also. By the way I was using Win95 that it could be the problem, but...

I made an Abit SE6 system and used a separate audio and video card. All I had to do is disable it in the bios. It works perfect without any conflicts.:)

This is what I did. I purchased a D-Link 701 cable/dsl router, and a D-Link 5 port hub. You need one NIC in each computer, straight cable and there you go. It does everything automatically.

You can get a lot of information here: http://www.homepclan.com Homepclan.com

In my system I have a D-Link 701 Cable/Dsl router and a D-Link 5 Port Hub to share my cable modem with other systems in my Home Network. It works great.