Recent content by FMJGomerPyle

I'm looking for a program, driver, or something that will convert a SPDIF signal to an AC3 so that my receiver can play more than 2 channels when my sound card is sending 4. My receiver converts the SPDIF signal to PCM and just plays 2 channels, but when I use PowerDVD to watch a movie, it...

I'm looking for a program that will monitor the total amount of network traffic in and out of my computer during a 24 hour period. I want it to be able to disconnect my network connection once I've reached a certain amount of data. I've tried DU Meter but it won't disconnect my network...

I don't have a manual and the diagram on the amp doesn't have anything about bridging. I would think this would be common among amplifiers.

I have a 4 channel amp that needs to power two subs. The amp has 8 speaker connections on it, each group of two labeled 1 2 3 and 4. It has two bridging buttons labeled "1/2 Bridge" and "3/4 Bridge" Once those buttons are pushed, where do I connect the positive and negative of each speaker?

I had this problem when I installed 2000 a while ago. It had to do with my hardrive scattering data while 2000 was installing, or something like that. I used the disk that came with my harddrive to write all zeros to the drive and then install 2000 and it worked.

if when he formatted the drive he didn't write unformat information to the drive then recovery is impossible. the data is gone

i have an ati tv wonder ve and i want to watch/record tv in linux. i think linux already installed the drivers for it, i just need a program that uses it. any suggestions?

that's what i'm going for. i'll probably be putting plenty of posts here.

nevermind, that worked thank for the help

do i need that even if there's only one partition on the drive?

ok, i compiled 2.4.12 and i'm pretty sure everything went ok. i added support for ntfs drives in the menuconfig. here's what i have in the fstab: /dev/hdb /mnt/storage ntfs defaults 0 0 when i do mount /dev/hdb i get this error message: mount: wrong fs type, bad...

sorry, i only have 7.1. my mistake. i'll try compiling the latest kernel

I have RH 7.2 kernel version 2.4.2-2 I want to mount a NTFS 5 partition. Someone said I could only do this as read-only with a new kernel. Questions: what kernel do I need? how do you install/compile a new kernel?

When you set up the options for burning the audio cd, there should be a tab that says "CD Text". At least there is in version 5.5.2.4 Don't know if that's the latest version or not.

what exactly is a dynamic disk? i've seen how to change mine to dynamic disks, what does it do?