Recent content by FlyingPigGod

  1. F

    VNF3-250 Doesnt like my 6800 GT?

    I tested it out on another PSU and it still had the same problem. I put my old 9800 pro back in to make sure it still works fine and it runs perfect.
  2. F

    5.1 speaker setup

    Before i switched back down to 2.1 I had my 5.1 setup on the ceiling. It was very easy to do most speakers have a place where you can stick a screw through for mounting. I also did this for a friend with some z5300s. If you goto a hardware store and tell the person what you are doing and what...
  3. F

    VNF3-250 Doesnt like my 6800 GT?

    Can I plug an extra molex connector off of another computers PSU into the video card to test it or does it have to be run off my power supply? If I can do this I can just take my comp to a friends house and test the PSU theory.
  4. F

    VNF3-250 Doesnt like my 6800 GT?

    Yea, I have the latest chipset drivers.
  5. F

    VNF3-250 Doesnt like my 6800 GT?

    I used driver cleaner when i installed. I did not reformat this time because i tried it with my first GT and it didnt help.
  6. F

    VNF3-250 Doesnt like my 6800 GT?

    I got a BFG 6800 GT a week and a half ago and RMAd it because i thought it was the card. I got my new one today and its doing the same thing. Everytime I try to play a game the game will run for a few seconds then freeze. It is not a permanent freeze but a choppy freeze where it freezes for 10...
  7. F

    Cleared CMOS, now will not boot

    Thanks for all the help, i think im just going to RMA it. I tried adjusting all the connections and different ram and different slots and nothing. I think I may just have a bad motherboard the AGP/PCI lock doesnt work, the onboard ethernet doesnt work and now this happened.
  8. F

    Cleared CMOS, now will not boot

    I was lowering my memory timings and I went too low. I set the CMOS clear jumper to clear and left it for 10 seconds (the manual said only needed 5) and nothing happened. i decided to leave it on the clear jumper settings longer (an hour), when i changed it back it started to boot up but froze...