Recent content by Eriksson

I dont know if your drives are ATA33 compatible, but you can choose from PIO 0~4, MW DMA 0~2 and UDMA 0~5. Perhaps you can only see the compatible settings for the drives connected to the controller. Btw ATA-100 drives are set to UDMA-5. Raid 0 = parallel access to all drives. For two drives...

To use RAID with two drives, plug each drive on separate controller (3&4 for Abit KT7-R) Make sure to put the blue connector to the motherboard, (80 wire cables) Both drives as master. Right after post screen press 'ctrl+H' to get into highpoint bios. There you can select boot drive should...