Recent content by enricong

I tried different memory, although I dont think that is the problem as the other CPU worked fine. If I remember right, the BIOS voltage settings are like "default, +.05, +.1, +.15" so I dont really know if I can set it to 1.25 or if that is default. I actually thought my BE-2400 was defective...

I am trying to setup a system with a Biostar K8M800 to work with a Athlon X2 BE-2400. When I power on, the fans and hard drive will spin, but there is no display, no beep, no post. I tried an Athlon64 4200+ and it works fine on the K8M800 so I'm not sure whats going on. I tried updating the...

how do those compare with the gladiator and my 60mm 38cfm delta? I'd like to get similar. I'm guessing that there isnt anyway to get a 60mm fan that can perform as well as my delta without the noise and I prob will need to use an 80mm fan. Should I get an 80mm fan and some sorta of...

I've had a tbird 1.3ghz OCed to 1.5ghz for a few years. It has a gladiator heatsink and a very loud delta fan. I remember when I first started using it, the temps would range from 48 - 54C. now it ranges from 52-57C. I'm not sure why. Anyways, I recently upgraded my computer and gave this...

well, I still have the CPU TEMP problem so I'll hold off on the celebrating for now :)

I switch to another Geil stick and the problem was solved. Thanks for your help

I got the bigger springs and also installed the 1/2 ID radiators. I had some trouble screwing in the connectors into the blackice micro holes, I couldn't get them all the way in because it was too tight and I started stripping the plastic. but there seems to be no leak. I've installed all this...

Actually, I thought about this. I planned to upgrade my CPU in about 18months so I planned to get some dualchannel ram and go up to 1gb I figure it would be better to get both sticks together and I could get something better for the same cost. oh well, I'll look for some ram

ok, I submitted my problem to MSI support and got this reply ----------------------------------------------------------------------------------------------------------------- It is not recommended to mix different brand, spec, CAS Latency, SPD, and timing of the memory modules into the newer...

RMA of what? the motherboard? the ram?

I'm at work now, I'll try it at night. but I don't know. I tried like 3838 or something like that last night and it didnt work.

they are in are already in slot one and three. I'll try setting the timings

ok, I tried setting the timing manually but no change. I tried only DDR2 or DDR3 and it still works.

I tried setting it down to 166 or 133 and I tried switching 1T and 2T what should I set my cas timings to? I'll try only slot 3 or slot 2 to see if thats whats going.

there are three slots The manual suggests DDR1 and DDR2 or DDR1 and DDR3 I tried all four combinations and I tried just having each one in there seperately Every time it says 256mb total the Geil is 2.5 6-3-3 1T 32x8 the Kreton is 2-3-3-7 32x8 according to the websites...