Yes I know, but in my country is F up the rma system.
If i go by that road who knows what will happen, at least I wont have a gpu for couple of months.
So first i must find out if it is really the card.
The problem is that in 3dmark 2011 and Drakensang i noticed at stock voltage artifacts, that is why i really want to find what is the problem.
At 1.15v at all 3d have artifacts.
I had active playing time for ~3 hours(more than once) so that must count.
But furmark or other benchmark i did not left it for more than 10 minutes.
No I don't have other good psu on my disposal.
Ok I have like them too but on other benchmarks with more voltage.
So it must depend from the textures what artifact will show.
For examle on Heaven 2.5 they have purple color.
Yes only voltage change the state of artifacts.
And after some time in 3D the artifact disappear.
But unlike...
Except I use modded bios, and use 11.1 hotfix, everything else is the same.
So I will try once again with my stock bios and wait long enough to clear, maybe they will be gone permanently that way.
So what and how long did you left until the artifact were gone?
And what clock and voltage you use with what program you manage?
Do you still have modded bios?
What driver, os ect... anything will help.
Thanks in advance.:thumbsup:
Temperatures don't go above 64 in vantage at 900 clock 1.175v.(I can pass the test like this, earlier the fan was set only to 25% fixed and gpu reach 95 degrees:D.)
I'v tried to go back to my original bios, but the artifact appear accordingly to amount voltage I apply, just like with modded...
I just record it now my artifact problem with MSIA.
Run vantage at 900/1300 with 1.2v on my unlocked 6950.
Here is the video:
http://www.youtube.com/watch?v=TiLl68BNHCA
And why at that voltage vantage stuck??
A tough all chips can at least work at 1.175 on 900 core without a problem.
Glad to, so "maybe" there is hope after all.
But sadly i don't have spare components to try.
And it is very strange that i have not find other cases like ours here.
Sorry for the double post, this is some updated info.
I now flash back to my original 1408 shader 6950 bios that i take from gpuz and keep it from day one.
And now apparently MSIA voltage works, so i try to raise just the voltage(clocks stays the same 800/1250).
And the same f*ing thing...
Yes i know but i wont risk it, i don't want my card to die eventually.
So is there someone that know what is causing this technically??
No need to be just for 6950.
I have the same problem with my sapphire 6950.
I found that my voltage is actually the vid3 in RBE but for some reason sapphire bios can't increase the voltage at all.
So now I use assus bios.
One strange thing i notice is that if i use 1.15v on vid3 i have small amount of artifact for the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.