Recent content by dball3

check firewalls,and network cards. and anyother programs u may be using for internet traffic. If u have a router check the settings in there as well

i would say it's good to go, i googled it and came to a shopping site that had the frontside bus listed as 1000mhz. So have fun building, and feel free to msg if u run into any probs.

i mean two different companies as the processor "amd" and the motherboard makers. they always seem to list the specs different.

the 2000mhz is actually a two way bus 1000mhz in both directions, and the 1600 is for older opterons i think that ran 800mhz both directions. So there won't be any underclock, its just two different companies with two different views on ht speed.

hi, just thought i would put my two cents in, i have the same board and have experienced the same issues while booting up. Nvidia's sata controller has some major issues, my problem was with maxtor drives and was pretty well documented on the web. I think your problem is very similar though...

I just wanted to clear something up for you, even if you have 2 sticks of ram, if one of those go bad it will affect your system. Your computer won't just skip over the bad stick, it will still try to use it, and you will get errors from it. So it would be best to run memtest on it, or run 1...

Well i've read recently, i think somewhere on the forums, the greatest speeds will be on the inner parts of the platters, and it gradually slows down as u move out. The other thing i was thinking is there is probably more than one platter in your drive and it might make a difference on how u...

I looked up a few websites and the only thing i can see about the 6100 memory clocks is that it runs off the system ram. http://www.answers.com/topic/comparison-of-nvidia-graphics-processing-units , here's the link, if you scroll down it says that it's shared memory, So that would explain not be...

i have had similar clicking from a hard drive and it turned out to be my power supply. one rail wasn't getting enough juice so i switched the plug with the one in the cd drive and it worked . So after that i went and got me a new power supply. and i'm still using the drive.

i had similar problems occasionally with my a8n deluxe, every so often i would get an error that the ntoskrnl or some file was corrupt on boot up and all i would change is the sata port and it would just boot up fine.

that magazine ad is just as bad, where the hell do the get these horrible ideas from. They really should try a little harder.

http://www.intel.com/homepage/index1.htm updated

Everytime i see the commercial, i just think why is this homely looking girl dancin around for intel. I really think they need to wipe out everyone who decided to make this ad campaign. It certainly isn't going to make me go out and buy intel, all it did was leave me scratching my head. Here's a...

i just looked around a bit and found this , i hope it helps. (Once you enter the JumperFree menu, the title changes to "Configure System Frequency/Voltage". As with most motherboards and of course ASUS boards in particular, extra options show up once you start changing values from...

i would check all the options for IE, it sounds like something maybe turned off or not set properly. And try updating java, something might have gotten eaten up in there and now IE can't read it properly.