Recent content by clkio

thx man, I will try and post back

I ran orthos and it gave me an error after 45 minutes 2:FATAL ERROR: Rounding was 0.5, expected less than 0.4 2:Hardware failure detected, consult stress.txt file. 2:Torture Test ran 47 minutes 34 seconds - 1 errors, 0 warnings. 2:Execution halted. 1:Torture Test ran 47 minutes 34...

ya, I am running Orthos now and it seems fine after lowering the cpu voltage even less (1.25) , I will just wait and check for errors now, thx guys

Hello guys. I got an E6300 running at 3.0GHz (P5B deluxe) I was just a little worried about the voltage, I am only giving it 1.3250, is that too low?? I mean the system is running perfectly without any problems. I guess i am a little concerned because people that are running that kind of speed...

if all you want is to over clock to 3ghz, the E6300 will do just fine, save yourself the 30bucks and spend it on some good ram. I can push my E6300 to 3.2Ghz without any problems, but I am happy with the 3. As for the over clocking board, I am really impressed with my asus P5B deluxe, its worth...

P5B deluxe is a nice overclocker, no problem wat so over with mine. But some people don't like it and they prefer gigabyte. As long as you got 200+ to spend on a mobo, anything will overclock nicely I beieve

I would go with an E6300 and over clock it to 3ghz or so, I am really happy with mine, and you get to save money. the voltage is at only 1.33V and 48C at full load

U ARE THE MAN, I FIXED THE CPU TEMP, it was over volting, I set it to 1.35V from auto. The cpu is running at 41C idle at 2.8GHz, thx a lot for the help guys

I will try that as soon as I get home. I also had another question, when I turn on the PC, it turns on then off for about 2 seconds, and comes back on to boot, why is this happenin? its been doing this since I got it and before I touched the overclocking.

I am using intlel's TAT, its reading 48 and 47 most of the times. so I think it is the core temp

all I did was increase the FSB to 375 and the voltage went to 1.4 didn't touch the SpeedStep or C1E

I downloaded a CPU Stability Test that ran for half an hour and the cpu temp went to 58 under burn which is not bad for full load , but it idles at 49, which is a problem. most people are idling at high 30s low 40s, I dunno why this is happening.

one more thing, the heatsink is very cool all the way around when I touch it.

yes it does. I have reapplied the thermal, its idling at 47-48 and load at 52. It's still kinda high, isn't?

ya, I really do think I applied the thermal paste wrong, I just applied it all over the place, I am going to reapply it right now and see what happens. And yes, the zalam is pusing the air to the rear fan and out of the case.