Recent content by Caal

DeMoNPauL How many HD do you have? Are they SATA? Use the base setting for a single SATA drive on the Intel ICH5R controller. [You have to map it to IDE Pri. Master]

Why rule out the Zalman? I have it and so do many other ppl. No one has reported any benefit from the DPS thing, infact there were a few who reported it causing instability. I never installed the DPS and all is well. Have you purchased memory yet? There have been many posts regarding...

harrillj, you don't say which memory sticks you have. Are they 512MB? Also which slots are they in? I also agree with the above suggestions except for the voltage - mine is only stable at default setting. This mobo & ram combo is tricky. My rig: Gigabyte 8KNXP, P4 2.8C, Corsair...

First off I also find the BIOS and the Gigabyte text very confusing. It's like a bad translation from Chinese. Some tidbits I can pass along: There are 3 RAID controllers: " on chip SATA" - the ICH5R, "Onboard H/W SATA" - the Silicon Image contoller [supports hot plug function], "GigaRAID...

Have you guys tried removing the DPS2 card? Someone in the Corsair forum found it to be the souce of his problems.

Nova: did you try to clear the CMOS? (Push the little lever on the battery, wait 20 seconds push the battery back in place)?

I just put together my set up. Corsair twinx1024 - 3200C2PT. SPD timings are cas 2.5, 8,3,3. I just backed up and will try to lower these settings.

Thanks fLoOdY. Good to hear that corsair works sometimes. I am waiting for my shipment to arrive. Anyone else have success stories with low latency corsair?

don49 Sorry if this is a stupid question but what exactly do you mean by "Give the ram some more juice" . Also which memory timings are you using?