If you're referencing this members results from a few pages back:
it's more than likely his CPU speed being clocked to 5.2GHz that gives him the 1.1 fps increase.
That linked picture is from my thread @ hardocp, nice.
What ultimately made me return the 120hz viewsonic came down to a few major things (to me):
1. 120hz ONLY works at 1680x1050 ( I wanted to use it at lower resolutions too - for older games such as quake3 or warsow - how could this...
I figure just to be on the safe side and to avoid any future conflictions...I might as well just move things to the seperate drive and do a clean install...I just dread the time it takes hehe.
..or should I completely format my hard drive and do a fresh install? I ask this because my current setup: AthlonXP 1800+, Abit (kt133a) KR7a motherboard...is about to be replaced by a 2400+ and an nForce II motherboard from ASUS. Will there be any complications foreseeable? I've installed...
Thanx...I'll probably run with that. So long as it can consistently give the watts needed I believe I'll be safe. If I were to upgrade I'd go Sparkle or another Antec. Thx again
Hi, I'm wondering if anyone has used an Antec 330w powersupply with the following components equal to or greater than - and if so...would the powersupply suffice:
Upgrading to--
AthlonXP 2400+
Crucial PC2700 DDR 256mb (x2)
ASUS A7N8X (will use onboard NIC & Sound)
VANTEC AeroFlow VA4-C7040 HS/F...
Just assembled a simple computer that's going to act as a server. Specs are:
Midtower - 300watt powersupply
Abit KT7e
AMD Duron 900MHz
2x 256 Crucial PC133 2-2-2 SDRAM
IBM 20GB, ATA/100, 7200rpm ( 60GXP )
Sony 52x cdrom
3dfx Voodoo3 3000 agp
3Com NIC /w wake on LAN
Teac 1.5" floppy
Arctic...
I am using a set of Aiwa speakers w/ subwoofer for making music. Have them sitting on a shelf right above the monitor. I also have a pair of desktop speakers...Altec Lansing 2 piece. Why not have both if moneys not an issue.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.