Recent content by atasp8

  1. A

    P8P67 Pro Problems (yeah another one) - keeps rebooting - flashing leds

    I did was update the BIOS immediately so this isn't quite an apples to apples comparison (0804 to 1053 beta) I just tried the 5 port setup and everything is working fine. I specifically picked this board because it contained so many SATA ports. xcept one of my seagate 2TBs keep falling out of...
  2. A

    Asus p8p67 wont post, no beeps, just black screen with YOUTUBE vid

    I know you can get the red CPU led to turn on if you did not plug in the 4pin/8pin EPS line. Though this doesn't seem to be the case here.
  3. A

    ASUS P8P67 Pro RAM Issues and BIOS Flash (Fix)

    I agree with BIOS/USB Flashing instead of using the windows updater. Had a bad experience a few years ago where the default setting of auto OC on the ASUS board probably caused it to fail updating the BIOS when using the windows updater. Crashfree also wasn't as mature back then and I had no...
  4. A

    P8P67 Pro Problems (yeah another one) - keeps rebooting - flashing leds

    I ordered online from NCIX. But I went instore to do the RMA. The tech instantly knew what the issue was when he saw the flashing lights and promptly replaced the board. Not sure if this means it is common.
  5. A

    P8P67 Pro Problems (yeah another one) - keeps rebooting - flashing leds

    The beep pattern is the "no memory" one and the MemOK LED is a solid red when that happens. This makes me think the BIOS is not completely dead. However, I've never seen anything on the screen once it had this problem. Yeah I've tried the MemOK button. It can switch into the MemOK mode but it...
  6. A

    P8P67 Pro Problems (yeah another one) - keeps rebooting - flashing leds

    I've also tried swapping out the battery with another one but no change. I found this thread at XS http://www.xtremesystems.org/forums/showthread.php?t=264597 I have the same problem described here except I am unable to recover from it by resetting the CMOS. The LEDs blink (cept the Boot...
  7. A

    P8P67 Pro Problems (yeah another one) - keeps rebooting - flashing leds

    I just tried the 5min clear CMOS and the extended instruction clear CMOS. No luck. I forgot to add to the description that there are no beeping noises when it is in this state. I can get it to beep if I don't install RAM. Any other suggestions?
  8. A

    P8P67 Pro Problems (yeah another one) - keeps rebooting - flashing leds

    Thanks for the suggestions and hope that it can be brought back to life. Yeah I've tried the one stick of memory and no hard drive approach (as seen in the video cept dark) but no luck. I haven't tried leaving the jumper for extended periods (longer than 1min) but will try that too. I know...
  9. A

    P8P67 Pro Problems (yeah another one) - keeps rebooting - flashing leds

    I put together my 2500K + P8P67 Pro setup last night and it worked until I tried to move to my 4 disk-RAID setup. The system was running on an OCZ 60GB SSD when it was able to turn on. Needing to switch the SATA mode from the default ACHI to RAID in the new bios I rebooted. This was the last...