Recent content by AquaLeviathan

The typos mean: 1gif+ =1 Gig+ FSP = FPS =first person shooter

:Q 5.25!? I hope you meant 1.525. Lower your HTT multiplier to 3x or 4x.

Sweet. Reflashed the official 1.9 and the USB2 option in the bios reappeared. It wasn't that I needed the extra usb speed, but it was annoying how the message would popup every time I used my thumbdrive. :P Thanks guys!

Hm.. I've always flashed using WinFlash. There's no difference between that and the floppy method suggested by MSI, right? I guess I'll flash again and see what happens. I'll post the results in a little bit.

Duvie, could you look in the device manage under usb ports? Do you see "enhanced" ports? If you do, USB2 is available.

Mark or Duvie, can either of you confirm if the 1.9 bios disables USB2? See my post above for why I want to know.

If you want more space, why not go with dual monitors? I don't think I would even be able to stand that high of res + that low of a refresh rate. Also, a bigger monitor will give you more room at the same res.

SPD may not be the right setting. Try setting up some dividers. What ram is he running (I know it's Crucial value)? PC3200/ddr400?

The actual barebone is the SN41G2. Drivers can be found here.

Also, the integrated mem controller on the A64s makes it hard/impossible to add support for faster RAM. You won't ever see DDR2 support for the current 939/940/754 procs because of this.

And you might have crushed the core since part of the core was under the hsf and part wasn't.

PC Toys uses rebadged Zalmans, IIRC.

Sorry for bumping an old thread :D I'm running a Neo2 with the official 1.9 bios and a 4400. Everything is smooth except for the USB ports. My ports don't get detected as USB2 ports, so I get the "Hi-Speed USB Device Plugged into non-Hi-Speed USB Hub" message when using my Cruzer. Things...

Think about it. If the 12v rail was really at 2v, do you honestly believe your computer would run? :P

Yes. It'll be fine.