Recent content by alyks42

why the useless posts? I think I'm just going to return my graphics cards, and buy the evga cards.

ok, so SFR works fine. With AFR, I thnk the problem is that it turns off SLI, or something.

so, I think SLI is working, just not with AFR, I loaded up farcry with the show load balancing enabled, sure enough, the bar was moving showing the balancing. I took off the sli connector and noticed the bottom half wasn't being shown, so it's working fine with SFR, just not AFR. (Alternate...

I think the EZ card was in wrong, so I put it in the other way, and windows detected the second GPU, I tried running doom 3, but it crashed, so when windows started again, I uninstalled the drivers, reboot, then reinstall the drivers, and I ran doom 3's timedemo, and got 1 fps more.

and mine are nothing close to those benchmarks

The EZ thing is in this position: Card one ------------------------- | single card | | asus EZ | | dual cards | ------------------------- Card two

I just switched the cards, and the same result. I also switch the EZ thing and took out the first card, connected my monitor to the second card, and it works, so it's not the pci-e slot.

Each one works individualy. I'll look up about flashing the bios on my cards. No way in hell am I using sp2

So yes, based on what the manual says, and what online reviews say, It's in the right position.

#1 yes, and yes. The card says dual setup, or whatever on the bottom. #2 already checked, set on auto.

Brand new system WinXP SP1 DirectX 9.0c

I don't know for sure, that's just my guess.

I did the same thing, and it tells me SLI is enabled, but only one card is rendering, the first card.

yes to both questions

could we please be a bit more on topic?