Recent content by Akshay

my new module was reported by memtest86+ to be running at 2.5-4-4-8, while earlier was 2.5-3-3-7. and the memory transfer speed is less by 100mbps. Havent yet checked my modules with the memory datasheets by Hynix. Will be doing it once am home..... I have two things on my mind a. Will these...

hii thebestMAX, VM/400 doesnt have Post Reporter and SATA Support.

DieHardware, any thoughts on the change behaviour?

:o i should have thought so, world is moving ahead, only few stoneaged ppl like me use win98se :D ;) am clueless about the wonders ( and horrors) gaming over xp

Check this http://www.nforcershq.com/forum/viewtopic.php?t=2088 U might need to install WDM drivers. Also, preferably use drivers from Abit than nVidia. Or it could be static due to ur cabinate casing, though ideally it shld not be.

Hey DieHardware, Tried a installation again and failed. ran memtest86+ upto 3 passes with a almost half a million errors in test 4, test 5 and test 6. Test resulting in 99% of the errors. booted after 3rd pass. dint go further as the error count was increasing a lot after each pass. So...

Hii guys, Finally have put my system togather AthlonXP (BARTON) 2600+ A7N8X-VM/400 512MB DDR333 Single Stick Hynix Seagate 10Gig ST310212A (on primary master) Seagate 4Gig ST34321A (on primary slave) Sony RW 52x32x52 (on secindary slave) with 300w smps and other...

hey thermalpaste, where wld i get a mx440 for 2k. In mumbai? ofcourse its a lowend card, so instead, i can go for A7N8X-Vm/400 with IGP which can be upgraded to a better card later. wut say? any thoughts? I am planning to buy the mobo tomm...

Very right Kiwi. doing this upgrade on a very tight budget. Was planning for A7N8X-E-Delux, which doesnt have an IGP. But realised that , my existing Asus AGP-V3400TNT-TV is not supported by the mobo, and would require a new card. And a lowest end card like GF4MX440 would set me back by 3000INR...

I am planning to by A7N8X-VM/400 MoBo. The mobo specs on site says, it supports UltraATA 133/100. I currently have 2 harddisks 1. Seagate Medalist 4GB (Model ST34321A) 2. Seagate 10GB (Model ST310212A) Seagate site says, these are UltraATA-3 models. Will the harddisks work with the...