Recent content by 312e

It was 5V MEASURED, current 3A, dummy load is a 10 ohm 100W resistor, with a very good PSU. The wire became hot enough that the glue connecting the screw mount and the wire together melted. When using a normal phone charger, the USB cord was OK. I may be powering multimedia devices and USB...

The voltage was 5v. I unbridge PS_ON and GND (to turn it off) when not in use.

The power hub will power 12V multimedia devices and fans along with 5V barrel jack and USB devices.

I am making a power hub out of an old ATX PSU. All wires will be stripped except Molex (and maybe SATA) connector wires. 12V will be connected to barrel jacks, PC fan sockets, and (maybe) lighter plug sockets (the plugs in a car). 5V will be connected to a dummy load, USB sockets (and maybe more...